+2 votes
89 views
in Bug Report by (140 points)
Before the big end of april patch that just went live on the early access build I built a line of assemblers getting fed by two belts on top of each other. I put the splitters directly on the belts and they would feed in the assemblers. The top splitter had a belt going down to the assembler input. The bottom splitter was at the same height as the assembler input. Everything worked fine.

Now, when I remove the belt going from the top splitter to the assembler input, I cannot put it back as I get the message the the conveyor belt is too steep. I was under the impression that the max incline was increased and not decreased, so I see no reason that I can't make the same build as I could before. Is this a bug or working as intended.
Welcome to Satisfactory Q&A, where you can ask questions and receive answers from other members of the community.
In order to keep this site accessible for everybody, please write your post in english :)
August 28th update: We've removed downvotes! One major reason is because we don't want to discourage folks from posting legitimate suggestions / reports / questions with fear of being mass downvoted (which has been happening a LOT). So we now allow you to upvote what you like, or ignore what you don't. Points have also been adjusted to account for this change.
Please use the search function before posting a new question and upvote existing ones to bring more attention to them, It will help us a lot. <3
Remember to mark resolved questions as answered by clicking on the check mark located under the upvotes of each answer.
...