+6 votes
in Bug Report by (770 points)


     I wasn't sure whether to put this as a "Suggestion" or "Bug Report" but I felt this was close enough to a bug to warrant tagging it as such.

     When using Perpendicular Wall Conveyors attached to Wall Conveyors it is impossible to make a straight line as the Perpendicular Wall Conveyors are one foundation snap too close to the wall. This causes a lot of logistic and organization issues when trying to use Perpendicular Wall Conveyors. 

     Conclusion: The Perpendicular Wall Conveyors should be adjusted to line up Wall Conveyors so the conveyor will be parallel to the wall it is being built upon.

Thank you,


by (8.4k points)
This also has me really triggered. I hate floating belts, but I've got a case where I have a perfect double 90, and if I have to choose between having those perfect bends and having a wall conveyor perpendicular, then the choice is rather clear.
by (110 points)
Why is this not fixed yet its should be an easy thing just pull them out a little .
It tigresses my OCD every time I try using the Perpendicular Wall Conveyors..
Welcome to Satisfactory Q&A, where you can ask questions and receive answers from other members of the community.
In order to keep this site accessible for everybody, please write your post in english :)
August 28th update: We've removed downvotes! One major reason is because we don't want to discourage folks from posting legitimate suggestions / reports / questions with fear of being mass downvoted (which has been happening a LOT). So we now allow you to upvote what you like, or ignore what you don't. Points have also been adjusted to account for this change.
Please use the search function before posting a new question and upvote existing ones to bring more attention to them, It will help us a lot. <3
Remember to mark resolved questions as answered by clicking on the check mark located under the upvotes of each answer.