Triggering the fuse of the biomass generator

Question

If the Fuse of the biomass generator is triggered and if the associated overload has been eliminated. If the generator automatically starts again by itself. Backups should actually be turned on manually or right?

Answer 1

Not entirely sure what your question is there mate.

If you fuse a generator, you need to lower the power draw, or overclock the generator, then manually pull the fuse handle to turn the generator back on (click and drag). Then find a new power source for whatever you disconnected. Anything still connected to it when it starts back up will automatically resume production and the associated power drain.

Hope that helps.

Comments

Thanks for your answer,
I overclocked the generator > then the fuse lever fell > after I solved the problem  > the generator started without manual operation of the fuse lever

Is this normal or not ?
I hope I could explain it better

---

Ah, I think I see, so you fused a generator, then to clear the problem you over clocked it, but then it restarted without you manually resetting the breaker?